Nonlinear LBO Crystal

For magneto-optical isolator Terbium Gallium Garnet TGG Crystal

TGG is an excellent magneto-optical crystal used in various Faraday devices(Polarizer and Isolator) in the range of 400nm-1100nm, excluding 475-500nm.
Inquiry now
products Details

TGG (Terbium Gallium Garnet Crystal)


TGG crystal is an excellent magneto-optical crystal used in various Faraday devices(Polarizer and Isolator) in the range of 400nm-1100nm, excluding 475-500nm.

 

Advantages

· TGG has twice the Verdet constant of a terbium-doped glass.

· The thermal conductivity of crystalline TGG is an order of magnitude greater than a typical glass.

· Optical losses are lower for TGG than Tb-doped glasses.

· The combination of the above factors make TGG better suited to high average power applications. The principal limiting factor is thermally induced beam distortion. Beam distortion is less for TGG than Tb-doped glasses under the same power loading level.

 

Properties:

Formula

Tb3Ga5O12

Crystal Structure

[111]

Verdet Constant (632 nm)

-134 RadT-1m-1

Verdet Constant (1064 nm)

-40 RadT-1m-1

Thermal Conductivity

7.4 W cm-1 K-1

Refractive Index

1.95

Nonlinear Index, n2

8

Figure of Merit, V/a

27

Figure of Merit, V/n2

5

 

 

Specifications:

Orientation

[111] within ±15 arc min

Wave Front Distortion

< 1/8 wave

Extinction Ratio

> 30dB

Diameter

+0.00mm/-0.05mm

Length

+0.2mm/-0.2mm

Chamfer

0.1mm @ 45°

Flatness

< 1/10 wave at 633nm

Parallelism

<10 arc secs

Perpendicularity

< 5 arc min

Surface Quality

10/5 Scratch/Dig

AR coating

R<0.2%  AR @1064nm

Barrel Finish (10-6 inches)

55 ± 5

 

Attached following Extinction Ratio measurement reports:

related Applications
Nonlinear KTP crystal HGTR-KTP crystal
HGTR-KTP crystal
Nonlinear KTP crystal named Potassium Titanyl Phosphate (KTiOPO4 or KTP) is widely used in both commercial and military lasers including laboratory and medical systems, range-finders, lidar, optical communication and industrial systems.
Read More
Waveplate Waveplate
Waveplate
Waveplates (retardation plates or phase shifters) are made from materials which exhibit birefringence. The velocities of the extraordinary and ordinary rays through the birefringent materials vary inversely with their refractive indices. The difference in velocities gives rise to a phase difference when the two beams recombine. In the case of an incident linearly polarized beam this is given by a=2pi*d(ne-no)/l (a-phase difference; d-thickness of waveplate; ne,no-refractive indices of extraordinary and ordinary rays respectively; l-wavelength). At any specific wavelength the phase difference is governed by the thickness of the retarder. Transmission range:330nm-2100nm Thermal Expansion Coefficient:7.5x10-6/K .Density:2.51g/cm3  Half Waveplate The thickness of a half waveplate is such that the phase difference is l/2-wavelength (true-zero order) or some multiple of l/2-wavelength (multiple order).  A linearly polarized beam incident on a half waveplate emerges as a linearly polarized beam but rotates such that its angle to the optical axis is twice that of the incident beam. Therefore, half waveplates can be used as continuously adjustable polarization rotators. Half waveplates are used in rotating the plane of polarization, electro-optic modulation and as a variable ratio beamsplitter when used in conjunction with a polarization cube. Quarter Waveplate The thickness of the quarter waveplate is such that the phase difference is l/4 wavelength (true-zero order) or some multiple of l/4 wavelength (multiple order). If the angle q (between the electric field vector of the incident linearly polarized beam and the retarder principal plane) of the quarter waveplate is 45, the emergent beam is circularly polarized. When a quarter waveplate is double passed, i.e. by mirror reflection, it acts as a half waveplate and rotates the plane of polarization to a certain angle. Quarter waveplates are used in creating circular polarization from linear or linear polarization from circular, ellipsometry, optical pumping, suppressing unwanted reflection and optical isolation. Optically Contacted Zero-Order Waveplate   • Optically Contacted • Thickness 1.5~2mm • Double Retardation Plates • Broad Spectral Bandwidth • Wide Temp. bandwidth Specifications: Material: Optical grade Crystal Quartz Dimension Tolerance: +0.0,-0.2mm Wavefront Distortion: <l/8@633nm Retardation Tolerance: <l/300 Surface Quality: 20/10 Scratch and Dig AR Coating: R<0.2% at center wavelength Standard wavelength: 532nm, 632.8nm, 800nm, 850nm, 980nm, 1064nm, 1310nm, 1550nm Cemented Zero-Order Waveplate Cemented by Epoxy Better Temperature Bandwidth Wide Wavelength Bandwidth AR Coated, R<0.2% Specifications: Material: Optical grade Crystal Quartz Dimension Tolerance: +0.0,-0.2mm Wavefront Distortion: <l/8@633nm Retardation Tolerance: <l/500 Surface Quality: 20/10 Scratch and Dig AR Coating: R<0.2% at center wavelength Standard wavelength: 266nm, 355nm, 532nm, 632.8nm, 800nm, 850nm, 980nm, 1064nm, 1310nm, 1550nm Air Spaced Zero-Order Waveplate Double Retardation Plates AR Coated,R<0.2% and Mounted High Damage Threshold Better Temperature Bandwidth Wide Wavelength Bandwidth Specifications: Material: Optical grade Crystal Quartz Dimension Tolerance: +0.0,-0.2mm Wavefront Distortion: <l/8@633nm Retardation Tolerance: <l/300 Surface Quality: 20/10 Scratch and Dig AR Coating: R<0.2% at center wavelength Standard wavelength: 266nm, 355nm, 532nm, 632.8nm, 800nm, 850nm, 980nm, 1064nm, 1310nm, 1550nm Single Plate Ture Zero-order Waveplate 1.Broad Spectral Bandwidth 2.Wide Temperature .Bandwidth 3.Wide Angle Bandwidth 4.High Damage Threshold Specifications: Material: Optical grade Crystal Quartz Dimension Tolerance: +0.0,-0.2mm Wavefront Distortion: <l/8@633nm Retardation Tolerance: <l/500 Surface Quality: 20/10 Scratch and Dig AR Coating: R<0.2% at center wavelength Standard wavelength: 1310nm, 1550nm   Cemented Ture Zero-Order Waveplate Cemented by Epoxy Wide Angle Acceptance Better Temperature Bandwidth Wide Wavelength Bandwidth   Specifications: Material: Optical grade Crystal Quartz Dimension Tolerance: +0.0,-0.2mm Wavefront Distortion: <l/8@633nm Retardation Tolerance: <l/500 Surface Quality: 20/10 Scratch and Dig AR Coating: R<0.2% at center wavelength Standard wavelength: 532nm, 632.8nm, 800nm, 850nm, 980nm, 1064nm, 1310nm, 1550nm Cemented Achromatic: Achromatic waveplate is similar to Zero-order waveplate except that the two plates are made from different materials, such as crystal quartz and magnesium fluoride. Since the dispersion of the birefringence can be different for the two materials, it is possible to specify the retardation values at a wavelength range. Material: Optical grade Crystal Quartz and MgF2 Dimension Tolerance: +0.0, -0.2mm Wavefront Distortion: < l/ 8@633nm Retardation Tolerance: <l/ 100 Surface Quality: 20/10 Scratch and Dig AR Coating: R<0.2% at center wavele...
Read More
BK7 Windows Customized Photonics BK7 Windows
Customized Photonics BK7 Windows
This kind of BK7 Windows is made from SCHOTT N-BK7 Glass, which has transparent range from 330-2100nm.
Read More
BBO crystal Nonlinear optical Phase matching Frequency doubling SHG THG FHG SPDC β-BaB2O4 BBO Crystal
Nonlinear optical Phase matching Frequency doubling SHG THG FHG SPDC β-BaB2O4 BBO Crystal
BBO is a nonlinear optical crystal with combination of number of unique features. Wide transparency and phase matching ranges, large nonlinear coefficient, high damage threshold and excellent optical homogeneity provide attractive possibilities for various nonlinear optical applications.
Read More
YCOB Crystal YCOB Crystal (YCa4O(BO3)3 )
YCOB Crystal (YCa4O(BO3)3 )
YCa4O (BO3) 3 (YCOB) crystal has superior nonlinear optical properties, high temperature piezoelectric properties and good chemical stability
Read More
BK7 Cylindrical Lenses Plano-concave Cylindrical Lenses
Plano-concave Cylindrical Lenses
Cylindrical lenses are mainly used to change the size of imaging per design requirements. Plano concave cylindrical lenses are mostly used in laser scanners, spectroscopy, dye lasers, acousto-optics, optical processors and other optical applications.
Read More
Fused Silica Windows Customized Photonics Fused Silica Windows
Customized Photonics Fused Silica Windows
Fused Silica Window is made from the material of fused silica. Fused Silica is a superior optical material possesses excellent optical, chemical and physical properties which is formed by chemical combination of silicon and oxygen.
Read More
Sapphire crystal Superior infrared material sapphire crystal
Superior infrared material sapphire crystal
Sapphire is a superior optical material possesses excellent optical, chemical and physical properties.
Read More
Multi-Coated Filter High Performance Fused Silica Multi-Coated Filter
High Performance Fused Silica Multi-Coated Filter
Multi-Coated Filter is made of optical materials such as Bk7, Fused Silica, Colored Glass, Sapphire and so on. Hundreds Optics offers Multi-Coated Filters include bandpass filters, dichroic filters, short-pass filters and long-pass filters.
Read More
Double convex lenses Positive Focal Length Double-Convex Lenses
Positive Focal Length Double-Convex Lenses
Double-convex Lenses are manufactured with an identical convex surface on both sides of the lens. This kind of lenses has positive focal length and form both real and vitrual images.
Read More
Plano Convex Lenses Plano-Convex Lenses for optical systems
Plano-Convex Lenses for optical systems
Plano-convex Lenses present a curvecd interface and a planar interface. Thay are for instance the microlenses situated on top of a wafer, and also encountered in macroscopic optical systems.
Read More
Wollaston Polarizer High Performance Optical Wollaston Polarizer
High Performance Optical Wollaston Polarizer
Wollaston Polarizer is made of birefringence material prisms that are cemented together. The ordinary ray in the first half of the prism becomes the extraordinary ray in the second half. The Wollaston Polarizing beam splitter has approximately twice the deviation for the Rochon Polarizer.
Read More
Send a Message
If you have questions or suggestions,please leave us a message,we will reply you as soon as we can!
Get In Touch
  • Tel : +86-591-22857792
  • Email : sales@100optics.com
  • Add : 3th Floor, Building 1, No 39 Jinlin Road, Cangshan District, Fuzhou Fujian,P.R.China.
Leave Message welcome to Hundreds Optics
If you have questions or suggestions,please leave us a message,we will reply you as soon as we can!

Home

Products

News

contact